REV020620
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 |
| 14 |
12.
Route battery-to-inverter cables (not included) through conduit (also not included) using the desired
knockouts on the side of the BOSS.6 Enclosure. DC Positive and DC Negative cables run from the
Enclosure’s 5-point terminal blocks to the inverter power panel of any equipment compatible with
SimpliPhi’s batteries (refer to the Integration Guides listed in the Product
Documentation section of
SimpliPhi’s web page for a list of compatible equipment:
https://simpliphipower.com/product-
13.
Set the circuit breakers for all battery modules to the ON position. PHI batteries must be fully charged
before commissioning.
CAUTION: Turn the inverter’s main DC Disconnect on only AFTER ALL the built-in circuit
breakers in the PHI Battery bank are turned on. (Refer to the System Commissioning
SimpliPhi battery video.)
This completes the installation procedure for the BOSS.6 Enclosure.
Remember, all Balance of System equipment must be programmed to SimpliPhi’s specified
settings and PHI batteries must be fully charged before commissioning the system (i.e.
before connecting the batteries to any loads).
4.0 – Care & Maintenance
The BOSS.6 Enclosure is designed to deliver many years of reliable service in a wide variety of
environments. The BOSS.6 is resistant to most environmental elements, but should be isolated from
excessive water or moisture, extreme heat, solvents, flammable materials, and environmental hazards.
If the BOSS.6 becomes dirty or grimy, wipe it as you would any kitchen cabinet. Do not use a pressure
washer or hose to clean the BOSS.6.