REV020620
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | (805) 640-6700 |
| 8 |
Required Tools for Installation
The following tools are required to assemble the BOSS.6 Enclosure:
•
Torque Wrench
•
9/16” socket
•
11/16” socket
•
17mm socket
•
Protective wear
Installation Site Location
The BOSS.6 Enclosure may be installed indoors or outdoors mounted onto a concrete pad.
The BOSS.6
Enclosure is NEMA 3R-rated for a degree of protection against debris, as well as rain, sleet and ice. The
Enclosure is NOT watertight and should therefore be protected against excessive exposure to liquids.
Keep the BOSS.6 Enclosure isolated from flammable materials or vapors.
Clearance Requirements
The BOSS.6 Enclosure can be installed directly adjacent to the AccESS or BOSS.6 fully integrated units.
Ensure that any ventilation is not blocked on the sides of the AccESS or BOSS.6 units. If mounting several
cabinets together, allow for at least 8” of clearance on the external sides not adjacent to each other for
ventilation, and 4 feet of clearance in front of the BOSS.6 Enclosure and/or AccESS or ExprESS units for
front door access. The BOSS.6 Enclosure can be placed flush against a wall, without any clearance at the
back of the Enclosure.
Knock-Out Location
Three Trade Size 1 knockouts are located on either side of the BOSS.6 Enclosure. They can be used for
routing battery cables from the enclosure to the inverter’s power panel. Not all knockouts must be used.
Pad Mounting
The BOSS.6 Enclosure must be installed and secured on level concrete. For a pre-cast concrete pad, a 4”
minimum thickness is required.