MON
Entry occurs every Monday
TUE
Entry occurs every Tuesday
WED
Entry occurs every Wednesday
THU
Entry occurs every Thursday
FRI
Entry occurs every Friday
SAT
Entry occurs every Saturday
SUN
Entry occurs every Sunday
WK0-WK9
Entry occurs on days designated by custom week (see
Section 8.1)
Hours
- Enter the two digit hour at which this entry is to be activated and press [ENTER]. The display will
advance to the minute’s position.
Minutes
- Enter two digits for the minutes and press [ENTER]. The display will advance to the AM/PM position.
AM/PM
- Press the [AM] [1] or [PM] [2] key, then [ENTER]. The display will advance to the first position after
the word RELAY.
Relays
- Enter the number of the relays you wish to be energized by this program entry. If a entry is entered
and a relay that is already energized should stay energized until the next entry, it is necessary to enter the relay
number again for this entry. The relay settings show the state of the relays at the programmed time of the entry.
The relay numbers will appear on the bottom
line as you press the appropriate number. Pressing the same
number again will remove the relay number from the bottom line. Once the relays are set, press [ENTER].
If
you have selected a secondary clock correction mode other than mode 0, relays 3 and 4 will not be
available for timed event functions.
The first entry (00) is programmed. The following display shows an
example of all relays being activated on Weekdays at 10:00 AM.
The Auto Prompt display will advance to the next entry (01).
Subsequent entries are entered the same way as the first. Continue until the last entry of Basic Plan #0 is
entered. Entry 19 (the 20th entry) is the last entry if you are using the default setting of 20 entries per plan. After
entering the last Entry, the master clock will advance to Basic Plan #1:
The master clock is now prompting you to enter the first of up to 9 alternate plans, plan #1. Plans 1 through 9
are entered the same as plan 0. If you are not using alternate plans 1 through 9, or if you have just entered
your last alternate plan, press [EXIT]. The master clock will return to the time display.
6.2 CLEARING A PROGRAM ENTRY
To clear a program entry, press BASIC [B], then [ENTER].
18
Summary of Contents for 6500
