5.6 REVIEWING OR EDITING THE RELAY 2 PULSE (MOMENTARY OUTPUT)
[5] [A] [ENTER]
To enter the pulse for relay two you must be at the time display. Press [5] [A] [ENTER]. The display will
respond with:
Once you have entered the pulse for relay 2 (Section 4.8) the master clock will return to the time display.
5.7 REVIEWING OR EDITING THE SECONDARY CLOCK MODE
[2] [0]
[ENTER]
Use mode 0 (disabled) if you are not correcting secondary clocks.
Type [2] [0] [ENTER]. Display will read:
See Section 4.9 for more details. For information on secondary clock modes not described in this guide, please
contact JCI Global Fire Detection Technical Support.
5.8 REVIEWING OR EDITING THE BASIC PROGRAM
[B] [ENTER]
If the basic program was not entered during the restart Auto Prompt sequence, it can be entered by entering the
basic program mode. This mode allows the operator to program the daily timed events. Before entering your
program be sure to write it out on a program record sheet. Copies of the program record sheet are located at
the back of this manual. You may need to change the size of your basic program if it requires more than 20
entries
. See SETTING THE MAXIMUM NUMBER OF ENTRIES PER PROGRAM (Section 7.3) for more
detail.
Press BASIC [B]. The display will respond with:
The master clock will now advance to the programming sequence.
16
Summary of Contents for 6500
