IDNet Cards
Installation Instructions
©
2003-2011 SimplexGrinnell LP. All rights reserved.
Specifications and other information shown were current as of publication and are subject to change without notice.
Simplex and the Simplex logo are trademarks of Tyco International Ltd. and its affiliates and are used under license.
574-800
Rev. D
This publication describes the installation procedure for the following:
•
4100-3101 IDNet Card – 250 Devices (742-476)
•
4100-3104 IDNet Card – 127 Devices (742-817)
•
4100-3105 IDNet Card – 64 Devices (742-818)
•
4100-3106 IDNet Card w/Quick Connect capability – 250 Devices (742-954)
•
4100-9811 IDNet Card – 250 Devices (Aftermarket)
•
4100-9835 IDNet Card – 127 Devices (Aftermarket)
•
4100-9836 IDNet Card – 64 Devices (Aftermarket)
This product is compatible with 4100U and 4100ES Fire Alarm Control Panels (FACP).
IMPORTANT:
Verify FACP System Programmer, Executive, and Slave Software
compatibility when installing, or replacing system components. Refer to
the Technical Support Information and Downloads website for
compatibility information..
Upon unpacking your Simplex product, inspect the contents of the carton for shipping damage. If
damage is apparent, immediately file a claim with the carrier and notify Simplex.
This publication discusses the following topics:
Topic
See Page
Cautions, Warnings, and Regulatory Information
2
Introduction to the IDNet Card
3
Step 1: Installing the IDNet Card into the PDI
5
Step 2: Setting DIP Switch SW1
6
Step 3: Wiring to IDNet Peripherals
8
Troubleshooting
11
Introduction
Inspecting Contents
of Shipment
In this Publication
Summary of Contents for 4100-3101
Page 12: ...574 800 Rev D...
