Simpact Freeway 1200, Hardware Installation Manual

Page: 56 / 76

56 DC 900-1537B
Freeway 1200/1300 Hardware Installation Guide
Step 6:
Configure the boot parameters as described in Table 4–1 .
Table 4–1: Freeway System Boot Parameters
Boot Parameter Description
Boot Device
To boot over Fast Ethernet from the boot server using the primary
Ethernet (on the CPU board), set the boot device to
ff f fee e eii i i
or
ff f fee e eii i i00 0 0
.
To boot over Fast Ethernet from the boot server using the secondary
Ethernet board, set the boot device to
ff
f fee e eii i i11 1 1
.
To boot from the local disk, set the boot device to
ii i idd d dee e e== = =00 0 0,, , ,00 0 0
.
Processor Number
The only valid number for this parameter is 0 .
FTP User Name
If booting from the boot server, Freeway uses this name to log in to its
FTP (or RSH) user account. The default is
ff f frr r ree e eee e eww w waa a ayy y y
. This is not required
if you are booting from the local disk.
FTP Password
If booting from the boot server, Freeway uses this password to log in to
its user account. The default is
pp p paa a ass s sss s sww w woo o orr r rdd d d
. This parameter is optional. If
a password is given, FTP is used during system boot; if it is cleared, the
remote shell (RSH) protocol is used.
Flags
This parameter specifies whether you want Freeway to:
•
Autoboot two seconds after system reset, seven seconds after
system reset, or not at all
•
Display the version numbers of the
.mem
files
•
Force the primary boot network interface to operate at 10
megabits/second, half duplex
Enter the
Flags
value shown in Table 4–2 on page 58 that matches your
configuration requirements. The default
Flags
value is
0
. The
Flags
word is an inclusive “
OR
” of the desired bits for the individual func-
tions.
Freeway
Server
Name
Enter the system name assigned by the system administrator for this
Freeway.
Freeway Inet Address
Enter the Internet address assigned by the system administrator for
this Freeway in decimal dot notation (for example, 207.67.135.84).
Freeway Subnet Mask
If your Freeway is located on a subnet, enter the subnet mask in hexa-
decimal notation (for example, ffffff00).