Simpact Freeway 1200, Hardware Installation Manual

Page: 57 / 76

4: Configuring the Boot Parameters using the Local Console
DC 900-1537B 57
Boot Server Name
Enter the name assigned by the system administrator for the boot
server. Optionally, you can clear this field and the software will assign
the default name “
bootserver
.” If you are booting from the local disk,
this parameter is ignored.
Boot Server Inet Address
Enter the Internet address assigned by the system administrator for the
boot server in decimal dot notation (for example, 207.67.135.84). If
you are booting from the local disk, this parameter is ignored.
System Boot Directory
If the Freeway boot files will be stored in the home directory of the FTP
(or RSH) user account, clear this field. Otherwise, enter the full path
name of the boot directory. The default UNIX directory is
/usr/local/freeway/boot
. The default VMS directory is
SYS$SYSDEVICE:[FREEWAY.BOOT]
. For Windows NT versions earlier
than 4.0, the default directory is
c:\freeway\boot
. For Windows NT
4.0 or later, use the alias you have set up to point to the
freeway\boot
directory.
To boot from the local disk, set the system boot directory to
//
/ /ii i idd d dee e e
.
System Boot File Name
Enter the system boot file name for this Freeway. The default is
ff f fww w w44 4 488 8 866 6 6
.
Configuration File Name
This parameter contains the file that Freeway uses to configure the
physical devices and services. Enter the file name for your Freeway. The
default is
bb b boo o ooo o ott t tcc c cff f fgg g g.. . .pp p pcc c cii i i
. For any Freeway using ICP_IP virtual ICP
devices, the default is
bb b boo o ooo o ott t tcc c cff f fgg g g.. . .ii i ipp p p.. . .
Secondary Network
Interface
If the
Boot Device
is a local area network device (boot server), the
Secondary Network Interface
parameter should be cleared, which is
the default.
If the
Boot Device
is the hard or flash disk, this parameter specifies the
local area network device to be used after the Freeway boots. Set this
parameter to
ff
f fee e eii i i
to use the primary Fast Ethernet (on the CPU board)
or
ff
f fee e eii i i11 1 1
to use the secondary Fast Ethernet board.
Gateway Inet Interface
If your Freeway and boot server are on the same network, clear this
parameter, which is the default. If they are on different networks, enter
the IP address of the gateway processor on the Freeway’s network that
provides access to the boot server’s network.
Table 4–1: Freeway System Boot Parameters (Cont’d)
Boot Parameter Description