Simpact Freeway 1200, Hardware Installation Manual

Page: 53 / 76

4: Configuring the Boot Parameters using the Local Console
DC 900-1537B 53
Step 2:
Configure the console terminal to operate with the following communications param-
eters:
•
9600 bits per second
•
8 bits data
•
1 stop bit
•
No parity
•
xon/xoff enabled
Step 3:
Turn the power switch on the front panel on .
Step 4:
When prompted on the console screen, press <return> within 7 seconds to prevent the
autoboot attempt. The Freeway Boot System Main Menu shown in Figure 4–1 appears.
Note
The Freeway Boot System Main Menu is only accessible using the
local console connected to the rear of the Freeway unit. Later you
can access these same functions from any remote console using the
Freeway Interactive Menu as described in the
Freeway User
Guide .