User manual for - FLOW METER SPP-N118
Functions of buttons when editing numeric and switching parameters:
While editing numeric parameter:
•
change of current (flashing) digit
•
slide change of value (acceleration, deceleration, direction change)
While editing switch parameter - selection of switch parameter.
or
If numerical parameter is being edited, a short press of
[ENTER]
button
change edited position. A long press of
[ENTER]
button (at lest 2 sec.)
causes of display a
”SEt?”
ask, which allow user to make sure if change of
the parameter value is correct. If switch parameter is being edited, a short
press of
[ENTER]
button causes of display a
”SEt?”
ask. When
[ENTER]
button is pressed again (while
”SEt?”
is displayed) the new value of the
parameter is stored in EEPROM memory.
Pressing this button operator can cancel the changes done up to now (if they
were not approved by
[ENTER]
button after the
”SEt?”
ask) and come back
to menu
7.3.
MENU DESCRIPTION
“- - - -”
- password checking. If some password different from „
0000
” is set, then every
enter to main menu follows the entering of password. If entered password is
correct then first menu position will be displayed else warning ”
Error
”, and unit
returns to measurement mode.
Due to problem with direct displaying of “
m
” letter, it is exchanged with special sign
“ “. Independently in user manual letter „
m
” is used to make it more readable
(example:
“modE”
).
7.3.1.
“rELAy1” menu
This menu allows to configure the operation mode of relays and LEDs marked „
R
” (e.g. „
R1
”).
If there are few relay outputs available, then every output has its own configuration menu (e.g.
menu „
rELAy2
” for relay (LED) „
R2
”). Principle of the relays operation is described in
paragraph
CONTROL OF THE RELAY OUTPUTS
.
•
The relay outputs and LEDs (named
R
) can be controlled by due to current flow
rate, stored peak value, total flow counter or batcher counter,
•
If device is not equipped with one or more relay outputs, menus refer to this
relays are available, but apply to LED indicators only. In such case LEDs
indicates exceeding of particular thresholds.
“SourCE”
- parameter defining kind of result using to control state of this relay.
It can be set to one of three values:
“Flo”
- relay is controlled due to current flow rate value or stored peak of flow rate
(see “Hold” menu),
“bAt”
- relay is controlled due to batcher counter value,
“tot”
- relay is controlled due to total counter result.
26
MENU
ESC
ENTER
i
i
PAUSE
ENTER
