Simex SPI-638, User Manual

Page: 55 / 68

User manual - FLOW METER SPI-638
Register Write Range Register description
6Dh Yes 0 ÷ 1
“t unit” parameter in “rELAy4” menu (the unit of thresholds and
hysteresis while relay is controlled due to total flow counter value):
0 - unit; 1 - 1000un;
70h Yes 0 ÷ 1
“ modE ” parameter in “ HOLd ” menu (type of detected changes):
0 - peaks; 1 - drops
71h
72h
Yes 0 ÷ 999999
“ PEA ” parameter in “ HOLd ” menu (minimum detectable change,
no decimal point included)
73h Yes 0 ÷ 199
“ timE ” parameter in “ HOLd ” menu, maximum peaks' (or drops')
display time expressed in seconds
74h Yes 0 ÷ 1
“ HdiS ” parameter in “ HOLd ” menu (the type of values displayed on
the display ):
0
- current measurement value;
1
- peaks (or drops) values
75h Yes 0 ÷ 1
“ H r1 ” parameter in “ HOLd ” menu (the control mode of relay R1
and LED R1) :
0
- control depends on current measurement values;
1 - control depends on peaks (or drops) values;
76h Yes 0 ÷ 1
“ H r2 ” parameter in “ HOLd ” menu (the control mode of relay R2
and LED R2) :
0 - control depends on current measurement values;
1 - control depends on peaks (or drops) values;
77h Yes 0 ÷ 1
“ H r3 ” parameter in “ HOLd ” menu (the control mode of relay R3
and LED R3) :
0 - control depends on current measurement values;
1 - control depends on peaks (or drops) values;
78h Yes 0 ÷ 1
“
H r4
” parameter in “
HOLd
” menu (the control mode of relay R4
and LED R4) :
0 - control depends on current measurement values;
1 - control depends on peaks (or drops) values;
79h Yes 0 ÷ 1
“
HOUt
” parameter in “
HOLd
” menu ( the control mode of current
output):
0 - control depends on current measurement values;
1 - control depends on peaks (or drops) values;
A0h 2
Yes 0 ÷ 3
“ OUtmod ” parameter in “ OUtPUt ” menu (active current output
mode)
0 - current output disabled ; 1 - current output enabled with
4 ÷ 20mA mode; 2 - current output enabled with 0÷20mA mode ;
3 - current output controlled via RS-485 interface
Yes 0 ÷ 2 “ OUtmod ” parameter in “ OUtPUt ” menu (passive current output
mode)
0 - current output disabled ; 1 - current output enabled with
4 ÷ 20mA mode; 2 - current output controlled via RS-485 interface
55