Sime Green Planet I-HE 35 MF, User And Installation Instructions Manual

Page: 5 / 40

ANOMALIES AND SOLUTIONS
When there is a functioning anomaly, the
display shows an alarm and the blue lumi-
nous bar becomes red.
Descriptions of the anomalies with the rela-
tive alarms and solutions are given below:
– ALARM 02 (fig. 27/a)
If the water pressure detected is lower
than 0.5 bar, the boiler will stop and the
display will show “ALL 02”.
Bring the pressure back to normal by
means of the charge system (C) until the
pressure indicated by the transducer is
between 1 and 1.5 bars.
ON COMPLETION OF THE OPERATION,
MAKE SURE THE LOAD VALVES IS CLO-
SED.
If it is necessary to repeat the system
loading procedure, it is advisable to
contact qualified technical personnel
to check the seal of the heating system
(to check whether there are any leaks).
– ALL 03
Request assistance from qualified
t echnical personnel.
– ALL 04
Request assistance from qualified
technical personnel
.
– ALL 05
Request assistance from qualified
technical personnel.
– ALL 06 (fig. 27/c)
Press the key on the controls (2) to
re-start the boiler.
If the anomaly persists, request assi-
stance from qualified technical personnel.
– ALL 07 (fig. 27/d)
Press the key of the controls (2) to
re-start the boiler.
I f the anomaly persists, request assi-
stance from qualified technical personnel.
– ALL 08
Request assistance from qualified
technical personnel.
– ALL 09
Request assistance from qualified
technical personnel.
– ALL 10
Request assistance from qualified
t echnical personnel.
– ALL 13 (fig. 27/e)
Press the key of the controls (2) to
re-start the boiler.
I f the anomaly persists, request assi-
stance from qualified technical personnel.
– ALL 14
Request assistance from qualified
technical personnel.
– ALL 15
Request assistance from qualified
technical personnel.
– From “ALL 20” to “ALL 29”
Request assistance from qualified
technical personnel.
GAS CONVERSION
If it is necessary to change to a different
type of gas, request assistance only from
authorised technical personnel.
MAINTENANCE
2
Fig. 27/c
2
Fig. 27/a
Fig. 27/d
2
Fig. 27/e
175
125
60
Please refer to the maintenance schedule in Section 5
of this manual.
The boiler is supplied is supplied with an electrical
supply cable. If this is damaged in any way it should
be replaced only by a new cable from Hunt Heating
and installed by a qualifies technician.
Page 5 of 40