C3X LINK
8
9
• Disconnect the unit from the mains power supply in the
event of electrical storms and when not in use.
To avoid damage that could be caused by lightning striking
in the vicinity of your home, disconnect the units in the event
of electrical storms or when the system will remain unused
for prolonged periods.
• Avoid contact with liquids and exposure to damp.
Do not use the units near water (sinks, tanks, etc.); do not
place objects containing liquids on top of or near the units
and do not expose them to rain, humidity, dripping water
or spray; do not use water or liquid detergents to clean the
units.
• Prevent the units from overheating.
In order to permit adequate cooling, leave a gap of at
least 40 cm at the back of the Projector.
Do not obstruct ventilation openings.
Do not place the units near heat sources such as heaters,
radiators or other devices that generate heat (including
amplifiers).
Do not position the units in confined places (bookcase,
shelves, etc.) and, in general, avoid putting the devices in
poorly ventilated places where there would be insufficient
cooling.
• Never look directly at the projection lamp.
Never look directly at the lens when the projector is on since
the bright light could damage your sight. In this connection,
pay special attention to children.
• Be careful with the movements of the lens.
Do not put anyting into the side slots in the lens and make
sure there are no obstructions to the horizontal and vertical
movements of the lens.
• Position the unit on a stable surface.
The projector must be positioned on a stable, suitable
platform or be installed using a bracket for fixed ceiling
or wall installation. Do not rest the projector on the side
panels or on the rear panel when in operation.
• Do not insert objects through the openings in the unit.
Make sure that no objects are inserted inside the units. If this
should occur, disconnect the unit from the power supply
immediately and call an authorised technician.
• Energy saving
It is recommended to cut off the power supply to the
Projector and DigiOptic™ Image Processor units when
they are not used. In this way, besides obtaining consi-
derable energy savings, the internal electrical parts are
protected against wear.
IMPORT
ANT S
AFETY INSTRUCTIONS
