13
5. Use a 8 mm bit to drill the holes
Battery
Address Jumpers
12 Volt Connector
PIEZO Siren Connector
Battery Connector
Figure 4: Open Siren Unit
6. Fix the unit onto the installation surface.
7. Ensure that the Piezo Siren is connected to the
Piezo
connector (as shown
below).
Figure 5: Siren Connectors
8. Insert the battery into the battery clip and connect it to the
BAT
connector
(shown above).
Note: The battery shall be Installed/replaced by service man
The Siren will beep once and then the LED power will blink for a period of 30 seconds,
please wait to the end of the blinking before activating or learning.
