16
3.2.4Parking
3.2.4Parking
3.2.4Parking
3.2.4Parking the
the
the
the truck
truck
truck
truck securely
securely
securely
securely
When you leave the truck it must be securely parked even if you only intend to leave it
for a short time.
– Do not park the truck on an incline.
– Fully lower the load forks.
– Set the key switch (10) to the "0" position and remove the key.
–Drawing back the emergency brake switch (11).
– Fold in the folding side arm
Do not reach between the operator platform and the truck panel when you fold up the
folding platform.
3.3Safety
3.3Safety
3.3Safety
3.3Safety regulations
regulations
regulations
regulations for
for
for
for truck
truck
truck
truck operation
operation
operation
operation
Travel
Travel
Travel
Travel routes
routes
routes
routes and
and
and
and work
work
work
work areas
areas
areas
areas ::::
Only use lanes and routes specifically designated
fortruck traffic. Unauthorised persons must stay away from work areas . Loads must
onlybe stored in places specially designated for this purpose.
Driving
Driving
Driving
Driving conduct:
conduct:
conduct:
conduct:
The driver must adapt the travel speed to local conditions .
Thetruck must be driven at slow speed when negotiating bends or narrow
passageways ,when passing through swing doors and at blind spots . The driver must
always observe an adequate braking distance between the forklift truck and the
vehicle in front and must be in control of the truck at all times . Abrupt stopping
(except emergencies) , rapid U turns and overtaking at dangerous or
blind spots are
not permitted. It is forbidden to lean out of or reach beyond the working and operating
area.
Travel
Travel
Travel
Travel visibility
visibility
visibility
visibility ::::
The driver must look in the direction of travel and must always have
a clear view of the route ahead . Loads which affect visibility must be stored at the
rear of the truck.If this is not possible , a second person must walk in front of the truck
asa lookout.
Negotiating
Negotiating
Negotiating
Negotiating slopes
slopes
slopes
slopes and
and
and
and inclines
inclines
inclines
inclines ::::
Negotiating slopes or inclines is only permitted if
such roads are clean and have a non-slip surface and providing such journeys are
safely undertaken in
accordance with
the technical specifications for the truck in
question. The truck must always be driven with the load unit facing uphill. The
industrial truck must not be turned , operated at an angle or parked on inclines or
slopes. Inclines must only be negotiated at slow speed, with the driver ready to brake
at any moment.
Negotiating
Negotiating
Negotiating
Negotiating lifts
lifts
lifts
lifts and
and
and
and docks
docks
docks
docks ::::
Lifts and docks must only be used if they have
sufficient capacity,
are suitable for driving on and authorised for truck traffic by the
owner . The driver must satisfy himself of the above before entering these areas . The
truck must enter lifts with
the load in
front and must take up a position which does
not allow it tocome into contact with the walls of the lift shaft.