![background image](http://html1.mh-extra.com/html/silverline/955431/955431_manual_1273488008.webp)
8
GB
Operation
WARNING:
Ensure your compressed air supply operates within the
pressure range stated in “Specifications”.
Firing trigger
• To operate the nailer, press the Safety Catch (7) against the material.
Holding the nailer firmly by its handle, squeeze the Trigger (1) to fire the
nail into the material
WARNING:
Rapidly pressing the firing trigger could cause internal
damage and may invalidate the guarantee.
Exhaust
• Rotate the Exhaust Direction Dial (10) to direct the exhaust air away
from the operator
Nail depth adjustment
IMPORTANT:
Always test the fastener will penetrate by the correct
amount.
1. Fire a test nail into a piece of scrap material and examine the
penetration depth of the nail
2. Minor adjustment is made using the Depth Adjuster (9) to adjust for
different size nails and different materials with finer control
3. Major adjustment of the nail depth is made by changing the air
supply pressure. Reducing the air supply pressure will reduce the
depth that the nail penetrates.
WARNING:
Always ensure the air pressure is within the range stated in
the ‘Specifications’ section.
Clearing jams
WARNING:
Always disconnect the tool from the air supply before any
adjustment or maintenance is carried out.
Fastener jammed in magazine
1. Pull back the Magazine Spring Mechanism (6) so it locks by the
Magazine Release Catch (4)
2. Remove the obstruction using pliers
3. Reload the magazine and close securely
Fastener jammed in plate area
1. Open the Jam Removal Lever (8) and open the nail plate.
2. Remove the obstruction using pliers
3. Close the plate and jam removal lever and check the operation of the
safety lever before using the tool
Maintenance
WARNING:
Always disconnect the machine from the air supply before
carrying out any maintenance or cleaning.
Note:
Two Hex Keys (11) are provided with this air nailer that are suitable
for partial disassembly of this unit. These may be useful for cleaning,
unjamming and replacing parts. Such disassembly is not covered by this
manual.
WARNING:
Never use third party spares with this product. Only use spares
supplied by Silverline or an authorised Silverline stockist or repair centre.
• Keep your machine clean at all times. Dirt and dust will cause internal
parts to wear quickly, and could reduce its service life
• Clean the body of your machine with a soft brush, or dry cloth
• After each use, pour approximately 1.5ml of Air Tool Oil (3) into the Air
Inlet (2)
• If the tool stops working or only works intermittently, pour approximately
1.5ml of lubricating oil into the Air Inlet (2), and connect to air supply.
Operate the tool in short bursts. If this does not free the tool mechanism,
have the tool serviced at an authorised Silverline service centre
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
• As with other power tools, air tools should not be disposed of with
household waste
• Air tools may contain traces of tool oil and other lubricants and so must
be recycled accordingly
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
955431_Z1MANPRO1.indd 8
28/08/2013 09:51
Summary of Contents for 955431
Page 2: ...2 1 3 6 7 11 5 2 4 8 9 10...
Page 40: ...40 Assembly Diagram...