Worktop Jig
633488
5
silverlinetools.com
Left Hand Female Bolt Slots
• Place the worktop face down
• Place the jig face down with two plastic pegs in the countersunk Male Peg Holes (5) which are
indicated by an ‘M’
• Place the remaining two pegs in the Bolt Peg Holes (7) which are indicated by a 'B'
• Position the jig over the worktop as shown, before securing the jig into position with G-clamps
• The bolt slots need to be cut to a depth of 20mm. Do not exceed 8mm cutting depth with
each cut
• Follow the pattern, make one extra pass across the cut to clean off excess material
FEMALE
Left Hand Male Cut
• Place the worktop face down
• Place the jig face down with two plastic pegs in the countersunk Male Peg Holes (5) and push the
jig firmly against the post formed edge
NOTE:
Before clamping, ensure the jig is positioned correctly so that the worktop will not be cut
too short for the joint.
• Once the jig is in position secure firmly with G-clamps
• To start, place the router on the left hand side of the jig
• Only cut to an 8mm depth with each pass. Repeat the process until the cut is complete
• Make one extra pass across the cut to clean off excess material
MALE
Left Hand Male Bolt Slots
• Keep the worktop face down
• Place the jig face up with two plastic pegs in the countersunk Male Peg Holes (5)
• Place the remaining two pegs in the Bolt Peg Holes (7)
• Position the jig over the worktop, before securing the jig in position with G-clamps
• The bolt slots need to be cut to a depth of 20mm. Do not exceed 8mm cutting depth with
each cut
• Follow the pattern, removing any excess material by performing a final cut
MALE
90˚ Right Hand Joint
Right Hand Female Cut
• Place the worktop face down with the post-formed (front) edge facing you
• With the jig facing up, place two plastic pegs in the countersunk Female Peg Holes (4) which
are indicated by an ‘F’
• Place another peg in the relevant hole. This will depend on the width of the worktop being used
• Position the jig over the worktop edge (as shown), before securing the jig in position with
G-clamps
• Place the router on the left hand side. Always cut from left to right
FEMALE
• Only cut to an 8mm depth with each pass. Repeat the process until the cut is complete
• Make one extra pass across the cut to clean off excess material
633488_Manual.indd 5
15/06/2017 15:54