GB
│
9
■
SKV 1200 A1
WARNING! RISK OF INJURY!
►
Ensure that the rotary switch
3
is turned to
"0" before you place the blender
t
on the
blender drive
i
. Otherwise the appliance will
start immediately as soon as the blender
t
has locked into place .
3) Place the blender
t
on the blender drive unit
i
so that the lock tabs on the underside of
the blender
t
lock into the recesses on the
blender drive unit
i
. The symbol on the
blender
t
must be pointing to the symbol
on the appliance . Turn the blender
t
anti-
clockwise as far as it will go . The symbol
on the blender
t
must then be pointing to the
symbol on the appliance .
4) Add the ingredients .
5) Place the blender lid
r
with measuring cup
e
in position so that the lips of the blender lid
r
also seal the spout .
6) Turn the rotary switch
3
to the desired setting .
NOTE
►
The ideal speed depends on the consistency
of the items being mixed . The more liquid the
contents are, the faster you can mix them .
►
For short, powerful pulsed operation, turn
the rotary switch
3
anticlockwise to level P .
Level P does not lock into place so as not
to overload the motor . You should therefore
keep the rotary switch
3
in this position only
for a short time .
CRUSHING ICE
►
In order to produce crushed ice, place ice
cubes in the blender
t
, close it and turn the
rotary switch
3
approx . 7 times to level P
for 5 seconds . You may need to adapt the
above instructions depending on the quantity
and size of the ice cubes .
Adding more ingredients
1) Turn the appliance off using the rotary switch
3
.
2) Remove the blender lid
r
and add the ingredi-
ents
or
3) Turn the measuring cup
e
in the blender lid
r
clockwise as far as it will go and then take it
out . Add the ingredients gradually through the
opening in the blender lid
r
.
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch
3
(Position “0”) .
2) Turn the blender
t
clockwise so that the
symbol on the blender
t
is pointing to the
symbol on the appliance and remove it .
NOTE
►
Ideally, you should clean the blender
t
im-
mediately after use (see the section "Cleaning
and care") . This makes food residues easier
to remove .
3) Place the drive protection cover
u
back on
the blender drive
i
so that the symbol on
the drive protection cover
u
is pointing to the
symbol on the appliance . Turn the drive
protection cover
u
anticlockwise so that the
symbol on the drive protection cover
u
is
pointing to the symbol on the appliance .
Summary of Contents for SKV 1200 A1
