Silvercrest SKV 1200 A1, Operating Instructions Manual

Page: 12 / 95

■ 8
│
GB
SKV 1200 A1
NOTE
► If you wish, you can open the filling opening
8
on the lid
9
so that you can also fill in
ingredients during operation .
7) Turn the rotary switch
3
to the required level
(see the section “Speed settings”) .
After you have finished using your
appliance
1) Turn the appliance off using the rotary switch
3
(Position “0”) .
2) Press down the release lever
2
and move the
swivel arm
1
to the highest position .
3) Remove the attachment
0 q w
from the
socket
7
by pressing the attachment
0 q w
lightly against the socket
7
and turning it
clockwise at the same time (in the direction
of the arrow
) . Then you can remove the
attachment
0 q w
.
4) If fitted: remove the lid
9
.
5) Remove the mixing bowl
6
by turning it anti-
clockwise and then pulling it upwards .
6) Clean the appliance (see section “Cleaning
and care”) .
Working with the blender
WARNING! RISK OF INJURY!
► Always allow hot fluids to cool down to a
lukewarm temperature (approx . 30–40°C)
before adding them into the blender
t
.
WARNING! RISK OF INJURY FROM
SHARP BLADES/ROTATING DRIVE
UNIT!
► Never put your hand into the attached
blender
t
!
► Do not remove the blender
t
unless the
blades
z
are stationary .
► Operate the blender
t
only when the blender
lid
r
with the measuring cup
e
are attached .
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket
to prevent the appliance from being switched
back on unintentionally .
ATTENTION! PROPERTY DAMAGE!
► Never use the mixing bowl
6
and blender
t
at the same time! This will overload the motor!
► When working with the blender
t
we recom-
mend allowing the appliance to cool down
after 3 minutes of operation .
Proceed as follows to prepare the blender for
operation
t
. Use figure C on the rear fold-out
page as a guide .
1) Press down the release lever
2
and press the
swivel arm
1
downwards into the working
position .
2) Turn the drive protection cover
u
clockwise so
that the arrow on the drive protection cover
u
is pointing to the symbol on the appliance .
Remove the drive protection cover
u
and
place it to one side .