Silvercrest SHBSP 800 A1, Operating Instructions Manual, Page: 42 / 201

40
GB
6. Operation
6.1 Mains operation
Regardless of the charging state of the battery, the hair and beard trim-
mer can always be mains-operated.
1. Before switching to mains operation, ensure that the device is
switched off.
2. Insert the larger plug of the USB cable | 9 into the USB port at the
USB plug-in power unit | 10 .
3. Insert the small plug of the USB cable | 9 into the micro USB port | 8 at
the hair and beard trimmer | 4 .
4. Insert the USB plug-in power unit | 10 into an easily accessible wall
socket, the voltage of which corresponds to the rating plate of the
USB plug-in power unit. The wall socket must continue to be easily
accessible after the device is plugged in.
5. Switch on the device with the on/off switch | 7 .
6.2 Transport lock
If the transport lock is activated, the lock symbol | 20 is lit.
• Press and hold the on/off switch | 7 for approx. 3 seconds, in order
to switch the transport lock on/off.
- When switching on the transport lock, the lock symbol
| 20 flash-
es, before the display | 5 goes off.
- When switching off the transport lock, the device is switched on
and the display of the battery capacity | 16 appears.
• When connecting the USB cable | 9 to the mains power supply, the
transport lock is deactivated and cannot be activated again during
mains operation.
__291948_Haarschneider_Autokamm_B8.book Seite 40 Dienstag, 19. Dezember 2017 7:42 19