Silvercrest SHBSP 800 A1, Operating Instructions Manual, Page: 41 / 201

39
GB
5. Charging
WARNING! Risk of material damage!
~
The battery must only be charged using the USB plug-in power
unit
| 10 supplied. Charging via the USB port of other devices is not
permitted. The devices could be damaged.
NOTES:
• The charging time for the battery is approx. 90 minutes.
• The USB plug-in power unit | 10 consumes electricity for as long as it
is plugged into the wall socket. Pull the USB plug-in power unit | 10
out of the wall socket to disconnect the device from the mains.
• The capacity/charging state of the battery | 16 is displayed in per-
cent ( 5, 10, ... , 100% in increments of 5%).
• When the battery is almost flat, the red plug symbol | 19 flashes. The
device can then only be used for a short time without being connect-
ed to the electricity supply.
• When the battery is fully charged, the device can be used for ap-
prox. 60 minutes without being connected to the power supply.
• In order to increase the service life of the battery, we recommend us-
ing the device regularly and without extended storage periods.
1. Switch off the device with the on/off switch | 7 if necessary.
2. Insert the larger plug of the USB cable | 9 into the USB port at the
USB plug-in power unit | 10 .
3. Insert the small plug of the USB cable | 9 into the micro USB port | 8 at
the hair and beard trimmer | 4 .
4. Insert the USB plug-in power unit | 10 into an easily accessible wall
socket, the voltage of which corresponds to the rating plate of the
USB plug-in power unit. The wall socket must continue to be easily
accessible after the device is plugged in.
5. The red plug symbol | 19 is lit and the battery is charged. When the
battery is fully charged, 100% is displayed and the plug symbol | 19
goes off.
__291948_Haarschneider_Autokamm_B8.book Seite 39 Dienstag, 19. Dezember 2017 7:42 19