11
GB/IE/NI
product. If liquid should enter
the product, unplug the mains
plug immediately and have the
product repaired by a qualified
technician.
Only use accessories and addi-
tional equipment stated in this
instruction manual. The use of
other products or accessories
than recommended in the in-
struction manual may present a
risk of injuries for you.
FOOD-SAFE!
The
taste and smell of your
food are not detrimen-
tally affected by this
product.
Before use
Remove all packaging material before use.
It is important to clean the product before first
use or if it has not been used for a long peri-
od of time. See the “Care And Cleaning” sec-
tion for more information.
It is essential that the product is descaled at
regular intervals to maintain optimum steam
and extend the life of the unit. See the “Des-
caling” section for more information.
During the first use, you may notice some
smoke / vapour emitting from the rear of the
main unit
12
. It is normal as grease is usually
applied on some parts of the product during
the manufacturing process. After serval use of
the product, it will no longer occur. This is not
dangerous and will not contaminate or fla-
vour food during use.
Dividing plate
5
/
7
The top / bottom containers
6
/
8
can be
separated into two compartments each with
the dividing plates
5
/
7
. To do so, place
the dividing plate
5
/
7
into the designated
rails.
To setup a larger single steaming compart-
ment, remove the dividing plates
5
/
7
from
the top/bottom containers
6
/
8
.
Note:
The dividing plate (square shape, for
bottom container)
7
can only be inserted in
one direction. Ensure both locking tabs
32
en-
gage both holes
33
on the bottom container
8
.
Initial setup
Check and ensure that the mains voltage of
the mains power socket is according to the
“Technical Data” section.
Place the main unit
12
on a stable, even
surface.
Fill the water tank
10
with cold water to the
maximum level (see Fig A and G).
Note:
The water tank
10
has to be filled
with water at least up to the MIN mark
14
.
ATTENTION! HOT SURFACE!
Make sure that the water does not
exceed the MAX mark
15
. Other-
wise, hot water may spurt out of the product
during operation.
ATTENTION!
Do not add anything like sea-
sonings etc. to the water. This may affect the
steam flow and / or damage the surface of
the water tank
10
and the heating element.
First place the drip tray
9
onto the main unit
12
, ensure the tongues
34
are aligned with
the slots
35
.
Then place the bottom container
8
with in-
serted dividing plate
7
onto the drip tray
9
.
Now place food in the compartment of bot-
tom container
8
. Use the dividing plate
7
to ensure food do not mix.
If necessary, put the top container
6
on the
bottom container
8
, place food in the