35
Changing the treble setting (TREBLE)
After pressing the control dial three times, the treble setting (TREBLE) can be reached. The message “TRE” will appear on
the display together with the current level (e.g. “0”). To change the bandwidth of the treble, turn the control dial clockwise or
counter-clockwise. The bandwidth can be set in a range between “-7” and “+7”. It can be changed in increments of one.
The setting is saved either when the desired value is confirmed by pressing the control dial or through automatic storage
(don’t change anything on the device for approx. five seconds). If you confirm the selection by pressing the control dial , you
will reach the next possible setting. If you use the automatic storage, the device will return to the standard display.
Change in the volume ratio between the right and left speaker group (BALANCE)
After pressing the control dial four times, the settings for the ratio between the speakers connected on the right and left can
be reached (BALANCE).
The message “BAL” appears on the display along with the settings for the volume ratio between the right and left speaker group
(e.g. “BAL 2R“). To change the ratio between the speakers, turn the control dial clockwise or counter-clockwise. Depending
on the direction in which the control dial is turned, an “R” (right speaker group) or an “L” (left speaker group) will appear on the
display, together with a digit (e.g. “2R“ or “4L“). These provide information about the direction in which the volume ratio is
changed and about the amount of the change. The ratio between the right and left speaker group can be set in a range between
“8R” and “8L”.
The volume ratio between the speakers changes according to the setting and the volume will increase on one side according to
this setting and decrease on the other side.
Note:
If the ratio is set to “0”, the volume on both speaker groups is the same.
If the control dial is set to the maximum position of “8” on one of the two sides, the speaker group in the opposite side will
be mute. To change this, turn the control dial again.
The setting is saved either when the desired value is confirmed by pressing the control dial or through automatic storage
(don’t change anything on the device for approx. five seconds). If you confirm the selection by pressing the control dial , you
will reach the next possible setting. If you use the automatic storage, the device will return to the standard display.
Changing the volume distribution between the front and rear speaker group (FADER)
After pressing the control dial five times, the settings for the speaker distribution between the front and rear speaker group
(FADER) will be reached.
