SKGL 2000 A1
■
20
│
GB
│
IE
│
NI
│
CY
Troubleshooting
This section contains important information on fault identification and rectification.
The following table will help you to identify and rectify minor malfunctions.
NOTE
►
If the appliance malfunctions, the corresponding error code will be shown
on the display. You hear beeps and all buttons are locked. It is not possible
to make any entries via the control panel
. Please follow the instructions
below.
Fault
Possible cause
Remedy
The appliance will not
switch on.
The plug is
not connected.
Connect the mains adapter
correctly to the appliance.
The socket is not
supplying any power.
Check the house mains fuse.
The appliance is
damaged.
Contact the Customer Service
department.
ER1 appears on the
display.
There is a short circuit in
the system.
Disconnect the plug from the mains
power socket and contact the Cus-
tomer Service department.
ER2 appears on the
display.
The lower hotplate
-
has not been correctly
attached.
Ensure that the lower hotplate
-
is
correctly fitted.
ER3 appears on the
display.
The temperature of the
hotplates
-
is over
320°C. The appliance
has overheated.
Remove the plug from the mains
power socket. Wait until the appliance
has cooled down completely and then
reconnect the appliance to a mains
power socket.
NOTE
►
If you are unable to resolve the problem by applying any of the aforemen-
tioned methods, please contact the Customer Service department.
Disposal
Never dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of European Directive
2012/19/EU-WEEE (Waste Electrical and Electronic Equipment).
Dispose of the appliance via an approved disposal company or your municipal
waste facility. Please observe the currently applicable regulations. Please contact
your waste disposal facility if you are in any doubt.
Summary of Contents for 290943
Page 3: ...A B ...
Page 33: ...SKGL 2000 A1 30 GB IE NI CY ...
Page 63: ...SKGL 2000 A1 60 GR CY ...
Page 93: ...SKGL 2000 A1 90 DE AT CH ...