SilverCrest SHBD 600 A1
English - 11
6.2. Accessories
6.2.1. Scissors (7)
Use the scissors to manually remove hair in areas that are difficult to reach.
6.2.2. Comb (8)
Before using the hair & beard trimmers, use the comb
(8) to give your hair or beard a thorough comb through and remove any knots.
6.2.3. Blade oil (9)
After cleaning, add a few drops of blade oil (9) to the blade block (1) to keep the blade block
(1) moving freely.
6.2.4. Cleaning brush (10)
Use the cleaning brush (10) to remove any remaining hair from the blade block (1).
6.2.5. Thinning attachment (11)
The thinning attachment (11) supplied enables you to thin out your hair style without shortening
it all. The special design of the thinning attachment (11) ensures that only a section of the hair is
cut; the rest of your hair will remain its original length.
Fitting the thinning attachment (11) is similar to fitting a comb attachment (12). In order to fit the
thinning attachment (11), push it carefully onto the blade block (1) of the hair & beard trimmer
until both prongs of the thinning attachment (11) on the right and left lock into the recesses on
the hair & beard trimmer. To remove the thinning attachment (11), lever the prongs on the left
and right out of the recesses on the hair & beard trimmer and take off the thinning attachment
(11).
Please note: The thinning attachment (11) needs to be fitted so that the recesses of the thinning
attachment (11) are pointing in the direction in which the hair & beard trimmer moves.
6.2.6. Comb attachments (12)
With the comb attachments (12), you have the option of selecting a length setting of between 4
mm and 30 mm for the remaining length of the cut hair.
The cutting length adjustment switch (2)
(0.8 mm, 1.5 mm, 2.2 mm, 2.8 mm)
can also
be used to select in between stages if the cutting lengths specified on the comb attachments are
not exactly what you require.
Without a comb attachment (12), the hair is cut at a length of 0.8 mm and 2.8 mm. Use the
cutting length adjustment switch (2)
(0.8 mm, 1.5 mm, 2.2 mm, 2.8 mm)
to set the
cutting length you require.
