Silver Stream-In / Stream-Out - User Manual SR 1.0.4 – 10/2012
Page 74
Whiterock Business Park - 729 Springfield Road - Belfast BT12 7FP - Northern Ireland
Tel.: +44 28 9067 7200 | Fax: +44 28 9067 7201 | www.aptcodecs.com | [email protected]
5.3
SureStream – Decoder Configuration
Configuring the Decoder for using SureStream follows the normal procedure for creating as
many as desired receive streams (component streams).
A SureStream group will be displayed only if the RX Latency settings are equal on all compo-
nent streams of a group. This is a very important setting and must not be ignored!
On the Decoder section, the Re-Sequencer as the complementary part of the Diversity Gen-
erator MUST be enabled!
Figure 5-5: Shows a SureStream configuration on the Decoder with two streams received
The figure above shows a working Decoder configuration in principal. Again, two component
streams are received on the same ETH port; hence they are transmitted on a single port at
the Encoder end (as shown in the Encoder section).
On the Decoder, SureStream needs the Re-Sequencer to be enabled whenever more
than one stream must be received from the same Encoder, regardless of the Diversity
Generator level settings of the Encoder!
The RX Latency setting must be equal on each component stream of a SureStream
group!
