S i 3 4 5 4 - K I T
14
Confidential Rev. 0.1
The user may specify which registers to read (when the GUI is updated) by checking a box at the left of each
register name. Refreshing, polling, and RoM, all depend on these settings. Clear on Read registers are read only if
both the CoR check box is checked and the check box for the individual CR register is checked.
The user may read and write individual registers by using the “R” (read) and “W” (write) buttons at the right edge of
each register. The “R” and “W” buttons are disabled if the operation is not allowed for the type of register. The
display of the whole register file can be read and updated at once by clicking on the “Refresh” button.
The Register List displays the value of each register in binary and hexadecimal form. If a register has not yet been
read, then its binary value is displayed as all Xs, and its hexadecimal value is blank.
A register's hexadecimal value is displayed in a text box. If a register is not writable (RO or CR), then its text box is
gray and its hexadecimal value cannot be changed by the user. If a register is writable (RW), then its text box is
white and its hexadecimal value can be changed by the user. After changing a register's value, the user clicks on
the register's “W” button to write the new value to the register.
Summary of Contents for Si3454-KIT
