Silicon Graphics Rackable C2108-TY10, User Manual

Page: 34 / 122

12 007-5688-003
2: Server Installation
Outer Rack Rails
Outer rails attach to the rack and hold the chassis in place. The outer rails for the chassis extend
between 30 inches and 33 inches.
Install the Outer Rails to the Rack
5. Secure the back end of the outer rail to the rack, using the screws provided (see Figure 2-1 ).
6. Press the button where the two outer rails are joined to retract the smaller outer rail.
7. Hang the hooks of the rails onto the rack holes and if desired, use screws to secure the front
of the outer rail onto the rack.
8. Repeat steps 1-3 for the remaining outer rail.
Install the Inner Rail Extension
The SGI Rackable C2108-TY10 chassis includes a set of inner rails in two sections: inner rails and
inner rail extensions. The inner rails are pre-attached to the chassis, and do not interfere with
normal use of the chassis if you decide not to use a server rack The inner rail extension is attached
to the inner rail to mount the chassis in the rack.
Install the Inner Rails
Perform the following steps to install the inner rails:
1. Place the inner rail extensions on the side of the chassis aligning the hooks of the chassis
with the rail extension holes. Make sure the extension faces "outward" just like the
pre-attached inner rail.
2. Slide the extension toward the front of the chassis.
3. Secure the chassis with 2 screws as illustrated. Repeat steps for the other inner rail
extension.