Silicon Graphics Presenter, Owner'S Manual

Page: 29 / 60

17
Chapter 2
2. Troubleshooting
This chapter contains information on solving problems that you may
encounter when using Presenter.
If you think there may be a problem with your Presenter, read the following
sections to help isolate and solve it. If the problem persists after following
these suggestions, call your service provider.
Problems with the Presenter Monitor
The suggestions in the following sections will help you isolate the problem.
No Image
1. Check that the power cable is connected securely to the Presenter and
to a working wall outlet or power strip.
2. Check that the interface cable is connected securely to the Presenter and
to the correct connector on the rear of the workstation. (See
“Connecting the Cables” on page 3.)
3. Make sure that the workstation is turned on. There is no On/Off switch
on the Presenter. If the cables are connected correctly, the Presenter
turns on automatically when you turn on the workstation. The
Presenter takes about a minute to warm up to full brightness.
4. If you recently installed the Presenter board in your workstation, the
board may not be installed correctly, or it may be installed in the wrong
slot. Follow the instructions in the installation manual that came with
the board to make sure the hardware is installed correctly.