Silicon Graphics Altix XE320, User Manual

Page: 213 / 248

Device Settings
007-5466-001 185
Refer to Figure B-17.
• Event Log Targets : This section enables you to manually set the event log targets and
settings.
• List Logging Enabled : Check this box to activate the event-logging list. To show the event
log list, click on “Event Log” on the “Maintenance” page.
Note: The maximum number of log list entries is 1,000 events. Every entry that exceeds this
limit automatically overrides the oldest one in the list. If the reset button is pressed, all logging
information is saved; however, all logging data is lost if hard reset is performed or the system
loses power.
• Entries Shown Per Page : Enter the number of entries you want to display on a page.
• Clear Internal Log : Click this icon to clear internal event log from the memory.
• NFS Logging Enable : Click this box to enable NFS Logging that creates a Network File
System (NFS) for writing the event logging data.
• NFS Server : Enter the IP Address of the NFS Server.
• NFS Share : Enter the path of the Network File System in which the event logging data is
stored.
• NFS Log File : Enter the filename of the Network File System in which the event logging
data is stored.
• SMTP Logging Enable : Check this box to enable the function of SMTP (Simple Mail
Transfer Protocol) logging.
• SMTP Server : Enter the IP Address for the SMTP Server.
• Receiver Email Address : Enter the email address that the SMTP event logging data is sent
to.
• Sender Email Address : Enter the email address from which the SMTP event logging data is
sent.
• SNMP Logging Enable : Check this box to enable the function of SNMP (Simple Network
Management Protocol) logging.
• Destination IP : Enter the IP address to where the SNMP trap is sent.
• Community : Enter the name of the community if the receiver requires a community string.
• Click here to view the Supermicro Daughter Card SNMP MIB : Click this link to see the
SMLP card SNMP MIB.