Operating manual - English
Twister II
Copyright Silca S.p.A. 2017
16
7.6
CUTTING NARROW-BLADE LASER (SIDEWINDER) TYPE KEYS
(ART.HU41P-HU55P-
HU64P...)
The clamp can also be used to cut narrow-stemmed Laser (sidewinder) keys but requires the use of the adapter
(optional). Proceed as follows:
1) Open the clamps by loosening knobs (E) and (E1).
2) Place the tip stop bar into the groove.
3) Insert the adapter into the clamp.
4) Insert the key so that it butts against the bar.
5) Secure the adapter and key by tightening knob (E).
6) Remove the bar and repeat the same operations on the right-hand jaw.
Cutting
:
1) Before activating the start switch (Q) lower lever (I) close to the keys.
2) Start the cutting operation by activating switch (Q).
3) Lower the spindle, cut the key and stop at the beginning of the cut (cap.7.5).
• secure the spindle at this height.
• carry out the cuts using only lever (C).
Adattatori (opzionali)
Fig. 18
7.7 CUTTING KEYS FOR FICHET
The clamp can also be used to cut keys for FICHET (H profi le). Proceed as follows:
1) open the clamps slightly by loosening knobs (E) and (E1) (Fig. 6, page 7).
2) place the keys with the stop up against the clamp.
3) secure the keys by tightening knobs (E) and (E1).
Cutting:
Turn on switch (Q), lower the collet assembly and position on the beginning of the cut.
• secure the spindle at this height by means of knob (R).
• carry out the cuts using only lever (C).
Fig. 19