Operating manual - English
Twister II
Copyright Silca S.p.A. 2017
18
8.2
REPLACING THE LAMP
To replace the lamp:
1) Turn off the master switch and unplug the machine.
2) Loosen the two screws (W1) and remove the lamp protection (W).
3) Unscrew and replace the light bulb.
4) Fit the lamp protection (W) and secure with the two screws (W1).
Fig. 21
8.3 CHECKING AND REPLACING THE FUSES
The fuses should always be checked with a continuity measuring instrument (tester, ohmeter, multimeter etc.) as
a visible check may not reveal an electrical fault. Fuses must always be replaced with others of the same type
and with the same Amps, as shown in the manual.
The TWISTER II key-cutting machine has two fuses:
3,15 Amps rapid
for machines with
230 Volt
8 Amps delayed
for machines with
120 Volt
placed in the inlet socket, to protect the key-cutting machine from sudden changes in voltage or short circuits.
It is advisable to check the fuses if the machine is not activated by turning on the master switch. Proceed as
follows:
1) Turn off the master switch (P) and remove the power cord.
2) Remove the fuse board with the aid of a screwdriver.
Fig. 22
