Operating manual
Matrix ONE
Copyright Silca 2014
20
5.4
CUTTING LASER TYPE KEYS
1)
Disable the tracer point spring (chap. 4.4).
2)
Turn on the motor with the switch (Q).
3) Insert the two keys into their clamps.
4) Take care when positioning the keys:
-
Stop 0 for keys with stops (chap. 5.2).
-
Stop 1 / 2 / 3 for keys without stops, using the bar provided for tip stop (chap. 5.2).
Attention:
if the bar is used, remove it before making the cuts.
5) Grip the levers (C) and (D).
6) Press the button (D1) and lower the vertical carriage to start the motor.
7) Keep the clamp carriage still with the left-hand lever (C) and lower the tool unit by means of the right-hand lever
(D) until the tracer point reaches the cutting depth.
8) Without exerting pressure, turn the lever (D)
clockwise to lock the height reached.
9) Move the lever (C) to trace all the cuts on the key
with the tracer point.
•
For right-hand cuts it is advisable to make the
cuts by moving the tracer point from the head
to the tip.
• For left-hand cuts it is advisable to make the
cuts by moving the tracer point from the tip to
the head.
10) When side 1 has been cut, turn off the motor with
the switch (Q).
11) Remove the key blank only and turn it 180° to cut
side 2. The key has the same cuts on both sides.
12) Start the motor with the switch (Q) and make the
cuts.
Fig. 27
Fig. 28
D
