SMARTY 2000
Operating manual - English
6
GENERAL INTRODUCTIONS
The SMARTY 2000 key-cutting machine has been designed according to the specifications of the
Machine Directives. From the design stage risks for the operator have been eliminated in all areas:
transport, key-cutting, regulation and maintenance.
A special adhesive label is attached to the machine warning the operator to use goggles during the
cutting operations, and this is strongly recommended in this manual.
The material used in the manufacture of this machine and the components employed during use of the
machine are not dangerous and their use complies with standards.
Use
The SMARTY 2000 must be installed and used in the way laid down by the manufacturer.
If the key-cutting machine is used differently or for purposes different from those described in this
manual, the customer will forego any rights he may have over ILCO ORION Furthermore, unforeseen
danger to the operator or any third parties may arise from incorrect use of the machine.
Negligence in the use of the machine or failure on the part of the operator to observe the instructions
given in this manual are not covered by the guarantee and the manufacturer declines all responsibility
in such cases.
It is therefore indispensable to read the operating manual carefully in order to make the best use
of the SMARTY 2000 and benefit from its potential.
Further Risks
There are no further risks arising from the use of the machine.
Protection and safety precautions for the operator
The SMARTY 2000 key-cutting machine is built entirely to standards. The operations for which it has
been designed are easily carried out at no risk to the operator.
The adoption of general safety precautions (wearing protective goggles) and observation of the
instructions provided by the manufacturer in this manual eliminate all human error, unless deliberate.
The SMARTY 2000 key-cutting machine is designed with features which make it completely safe in all
its parts.
•
Power supply
The key-cutting machine must be supplied with electricity by means of a safety device (standard with
230V key-cutting machines, on request for other voltages). The plug must be earthed.
•
Start-up
The machine is started up by means of:
1) the main switch on the safety device (supplied with the 230V machines);
2) the ON switch, situated on the machine, which activates the machine motor.
•
Maintenance
The operations to regulate, service, repair and clean the machine have been devised in the simplest
and safest way possible. There is no danger of removable parts being replaced wrongly or unsafely.
•
Machine Identification
The SMARTY 2000 key-cutting machine is provided with an identification label which shows the serial
number (fig.2).
Fig. 2
Summary of Contents for Ilco Orion SMARTY 2000
Page 1: ... D430568XA vers 3 0 Operating manual SMARTY 2000 ...
Page 4: ......
