SMARTY 2000
Operating manual - English
16
7
KEY CUTTING
ATTENTION: for complete safety during the cutting operations, take the following precautions:
•
Always work with dry hands.
•
Check that the machine is properly earthed.
•
Use the protective goggles, even if the cutting tool is fitted with a protective shield.
•
Start the motor only when all the operations with the carriage have been carried out
(securing keys, etc...).
•
Keep hands away from the cutting tool when in motion.
•
Before duplicating, remove the gauges.
7.1
Key cutting
1) turn the clamps to find the appropriate side for securing the key (fig.9)
2) loosen the knobs (H1) (fig.9) by a couple of turns.
3) raise the lower part of the clamps and turn to the required position:
-
Side A
: for keys to be fitted on their backs (fig.9-B);
-
Side B
: for keys to be cut on both sides and locked on the groove (fig.9-B).
Securing the keys in the jaws
1) position the original key (left-hand jaw) and key blank (right-hand jaw), ensuring that:
a) the keys are positioned and secured;
b) the key stop is resting against the calibration tabs (B1) (fig.8-B);
2) secure the keys by closing the clamps with the knobs (H1) (fig.9).
Fig. 9
Key cutting
When the SMARTY 2000 key-cutting machine has been turned on by means of switch (D1) it is ready
for cutting:
1) take the carriage up to the tracer point and cutting tool.
2) to copy the key, move the carriage sideways from right to left by means of the lever (A).
3) turn off the machine with switch (D1) (fig.4, page 8) before removing the duplicated key.
4) remove the keys from the clamps.
5) turn on the machine with switch (D1) and smooth off the key edges by means of the brush (E) (fig.4,
B
A
H1
Summary of Contents for Ilco Orion SMARTY 2000
Page 1: ... D430568XA vers 3 0 Operating manual SMARTY 2000 ...
Page 4: ......
