Siko MSA510/1, Installation Instructions Manual

Page: 34 / 44

MSA510/1
Commissioning English
MSA510/1 · Date 04.05.2016 · Art. No. 83520 · Mod. status 38/16
34
Hex TX RX S P R Function
16 Hex 3 6 - - - read out position value
18 Hex 3 6 - - - read out calibration value
1b Hex 3 6 - - - read out device's characteristics
D-Byte 1: identifier = 23
D-byte 2: software version
D-byte 3: hardware version
1d Hex 3 6 - - - read out counting direction
value = 0: "up" (+)
value = 1: "down" (-)
1e Hex 2 3 - - - read out resolution
0= 10 mm; 1= 1 mm; 2= 0.1 mm; 3= 0.01 mm;
4= 1 inch; 5=0.1 inch; 6 = 0.01 inch; 7 = 0.001 inch
28 Hex 6 6 S P - program calibration value
Value to which the position value is set when the
sensor is zeroed (command 0x48).
2d Hex 6 6 S P - program counting direction
value = 0: "up" (+)
value = 1: "down" (-)
2e Hex 6 6 S P - program resolution
value range see command "1e Hex"
32 Hex 3 3 - - - programming mode ON
for parameter programming (0x28 and 0x2d), pro-
gramming mode must be "ON"
33 Hex 3 3 - - - programming mode OFF
default
3a Hex 3 6 - - - send system status
3b Hex 3 3 - - - delete system status
System status bytes 2 and 3 are deleted.
48 Hex 3 3 S P - Sensor zeroing
Position value is set to calibration value.
4f Hex 3 3 - - R freeze position value
Position value is freezed; the status is reset by
reading out the position value. Used for synchro-
nized readout of multiple sensors.
Error messages
The slave (sensor) recognizes transmission or input errors and then issues
the following error messages:
Hex TX RX S P R Function
82 Hex
- 3 - - -
check sum data transmission error
83 Hex - 3 - - - illegal or unknown command
85 Hex - 3 - - - illegal value (parameter programming)