Siko AP10S, User Manual, Page: 20 / 44

Functional Description
AP10S
Date: 12.05.2020 Art. No. 90304 Mod. status 110/20 Page 20 of 44
Description Display Chapter
Firmware Revision
VERSoN
5.1.2
Table 13: "Device data" menu
3.7.2 Restore factory settings
There are various options for restoring the factory settings of the device:
Access Coding Factory settings are restored
Manual CODE
(see chapter
4.5.8 )
011100 all parameters
Load Default
(see chapter
4.5.7 )
ALL
all parameters
Interface SystemCommands
(see chapter
5.3 )
130 (82h) all parameters
Table 14: Access to factory settings
3.8 Warnings / Errors
3.8.1 Warnings
Warnings have no influence on the recording of the actual value.
Warnings are deleted after removing the cause.
Possible warnings:

Battery voltage for absolute position detection is below limit

immediately exchange
battery!
This warning is displayed with a blinking battery symbol. Warning messages are output via
the interface via the StatusWord (see chapter
3.7 ).
Display Bit assignment in the StatusWord Error
flashing bs11_BatteryState Low battery voltage (critical)
PositionValue is still valid!
Table 15: Warnings
3.8.2 Errors
Calibration may also be required Depending on the error type.
Error states are signaled via display (written in red or battery symbol) and interface. The
cause of the fault can be determined using the event or error code (see chapter
5.5 and 5.6 ).
To return to normal operation, the cause must be removed (see Table 16 ). Error signaling can
then be acknowledged or deleted with the key (see chapter 2.3 ).
If calibration is required, this is indicated in the display as "
CALIB
". Independent of
acknowledgment of the error status.