Siko AP10S, User Manual, Page: 21 / 44

Parameter
AP10S
Date: 12.05.2020 Art. No. 90304 Mod. status 110/20 Page 21 of 44
(For signaling see chapter 2.1 .)
Display Bit assignment in the StatusWord Error
permanent bs11_Batter
bs07_GeneralError
Battery undervoltage (dead)
noMAGn
bs12_Senso
bs07_GeneralError Tape-sensor gap exceeded
noSENS
bs12_Senso
bs07_GeneralError No sensor connected
SPEED
bs12_Spee
bs07_GeneralError Travel speed exceeded
Table 16: Error messages
3.8.3 Corrective actions
Display Error Possible effect Corrective actions
permanent Battery empty Actual value not
reliable Battery
calibration travel
noMAGn
Magnet distance too large Measurement error
or no measurement Setting the sensor
di calibration
travel
noSENS
Sensor connection
interrupted Measurement error
or no measurement Check sensor
conn
calibration travel
SPEED
Permissible speed exceeded
(see installation instruction) Actual value not
reliable Traversing speed +
calibration travel
Table 17: Corrective actions
4 Parameter
All parameters stored in the EEPROM can be reset to factory default settings if necessary
(see chapter
3.7.2 ).
Chapter Starting with page
Process data 22
Positioning 24
Visualization 28
LEDs 29
Device options 32