5.2.1 Warning Indicators
When the ERROR LED flashes (as shown below), take the necessary actions according to the following
instructions. When the problems are solved, the ERROR LED will turn off automatically. Pressing the
ON/OFF LINE button can also turn off the ERROR LED.
Warning Indicators
ERROR
ON/OFF
LINE
REPEAT
DATA
CLEAR
CUT
TEST
1
Graph was clipped
2
HPGL/2 command Error
3
Lever up or no media
4
Cannot repeat
5
Communication error
6
Width sensor error
7
Check media, drum or X
motor
= flash
= off
Warning 1
The graph is clipped
This condition indicates that the cutting graph is bigger than the cutting area.
You can solve the problem by:
1
Reload a wider or longer media.
2
Move the pinch rollers to widen the cutting area.
3
Re-scale the graph to a smaller size. Then send the cutting job again from your computer to the
cutting plotter.
Warning 2
HPGL/2 command error if the cutting plotter cannot recognize the commands from your
computer, please check the commands applied to your cutting plotter in the HP-GL/2 or HPGL commands.
Then send the same job to the cutting plotter again.
If that doesn’t solve the problem, please contact your local dealer.
Warning 3
Lever up or no media. Check that you have lowered the lever down and make sure that you load
the media before cutting.
Warning 4
Cannot repeat cutting
There are two possibilities:
1
There is no data in the buffer: please send the job again from your computer;
2
The buffer is full: please send the same job from your computer again.
Under both conditions, press the ON/OFF LINE key to clear the warning message.
Summary of Contents for Enduracut
Page 1: ......
