User Manual
2614 Texoma Drive Denison, TX 75020 • 980 Contract St. Suite 110 Lexington, KY
Phone: 903-462-7700 or toll free 800-899-5655 • Fax: 800-966-6834
34
4.4 Cutting Force and Offset Adjustment
Before sending your designs from computer to EnduraCUT 2 for cutting, please make “Cut Test” to
adjust cutting force and offset value.
The “Cut Test” should be repeated several times until the optimum settings are achieved.
Please follow procedure below to optimum the cutting force and offset settings.
Step1.
After sizing the media, press [CUT TEST] button to select the “Square Cut”, and press [ENTER KEY]
to confirm.
The default cutting force and offset value of the cutting test are 80gf and 0.275mm respectively.
Step2.
Press [ARROW KEY] to move the tool carriage to the position where you would like to cut. Then,
press the [ENTER KEY] to make a “Cut Test”.
Note: At the same time, the new origin is also set at the cut test position.
Step3.
When the “Cut Test” is completed, a pattern appears (please refer to Figure 4-7). Peel off the
pattern to see if it can be easily separated from the media base. If the output result is good, the
cutting force is set appropriately. The desired result is a cut throught the vinyl and adhesive and a
very light scoring of the release liner. The vinyl should be easy to remove from the liner.
If the cut vinyl cannot be easily removed from the liner, or if the release liner has also be cut, press
[FORCE KEY] to adjust the tool force until an optimum force is obtained.
Cont’d next Page...
