Signamax
FO-065-7732A Manageable Gigabit Switch
10 User’s Manual
I n s t a l l a t i o n
This chapter gives step -by-step instructions about how to install the
switch:
Selecting a Site for the Switch
As with any electric device, you should place the switch where it
will not be subjected to extreme temperatures, humidity, or
electromagnetic interference. Specifically, the site you select
should meet the following requirements:
-The ambient temperature should be between 32 and 104 degrees
Fahrenheit (0 to 40 degrees Celsius).
-The relative humidity should be less than 90 percent, non-condensing.
-Surrounding electrical devices should not exceed the electromagnetic field
(RFC) standards for IEC 801-3, Level 2 (3V/M) field strength.
-Make sure that the switch receives adequate ventilation. Do not block the
ventilation holes on each side of the switch or the fan exhaust port on the
rear of the switch.
-The power outlet should be within 1.8 meters of the switch.
Connecting to Power
Step 1: Connect the AC power cord to the receptacle on the back of the
switch, and then plug it into a standard AC outlet with a voltage
range from 100 to 240 VAC.
Or connect the DC power cord to the receptacle on the back of the
switch, and then plug it into a standard DC outlet with a voltage -
48 VDC.
Step 2: Disconnect the power cord if you want to shut down the switch.
Rear view