Chapter 1
Installation
1-2
1.1 SQM-242 Card Installation
Jumper each SQM-242 card before installation as shown below:
Card 1
Card 2
Card 3
Card 4
Card 5
Card 6
JP5
JP5
JP5
JP5
JP5
JP5
If you are installing a SAM-242 Analog piggyback card, it must be connected to Card 1.
Set the Card 1 jumper as shown below when the optional SAM-242 card is used.
Card 1 Jumper
with SAM-242 card installed.
Card 1 with SAM-242
Ribbon Cable installed.
JP5
The SAM-242 card can go on
either side of SQM-242 Card 1,
as long as the ribbon cable is
not twisted (red stripe on the top
or bottom of both cards).
Once each card is jumpered:
1. Turn off the computer, unplug the power cord, and remove the computer cover.
2. Locate an empty PCI slot and remove the screw holding the blank bracket for the
slot. Remove the blank bracket.
3. With the card’s gold contacts down, place it above the PCI slot with the BNC
connectors on the card extending through the back of the computer. Press down firmly
on the card to seat it into the connector. Repeat with each card.
4. Replace the screw at the top of the card bracket to secure the card. Replace the
cover on the computer and plug in the power cord.
