To cancel multiple exposure mode in mid-operation, repeat steps 1 and 2 so that "CE" is displayed or set the
mode dial to the
L
position.
4www.butku s.org
When taking multiple exposures on a single frame, you should decrease the exposure value for each exposure
using exposure compensation. (page 47). A general exposure compensation table is shown below. The actual
degree of compensation required depends on the shooting conditions and the subject.
Number of multiple exposures
Compensation amount
2 exposures
-1.0
3 exposures
-1.5
4 exposures
-2.0
OPTIONAL ACCESSORIES
To expandable the SA-5's photographing ability, we have developed some innovative accessories which are
described in this section.
This accessory permits releasing the camera's shutter from up to 6 feet (5 m) away from in front of the camera
to 9.8 feet (3 m) away if you are 30 degrees to either side. (Depending on the lens, there may be some
restrictions when using it from the left side of the camera.)
OPERATION
Description of Parts
1. Transmit Button
2. Time Delay Selector
3. Transmitting diode
4. Channel Selector (for RS-21 only)
1.
Select time delay
* Shutter will be released 1 second after the transmit button is
pressed.
*** Shutter will be released 3 seconds after the transmit button is
pressed.
2
. Set the camera's Drive Mode to the "Remote control".
Set to"C1" if you use with RS-11
Set to either "C1", "C2" or "C3" if you use with RS 21. Also set the
same channel on the RS-21 by sliding the channel selector.
4www.b utkus .org