![background image](http://html.mh-extra.com/html/sigma/chef-10/chef-10_use-and-maintenance-instruction-manual_1267775011.webp)
Instructions manual CHEF 10 VVE
11 of 19
Machine without pallet.
Due to its instability , the mixer must be handled with a suitably-sturdy strap, having it pass below
the head, as in the figure at the right.
Before lifting, stand the grid up vertically
Make sure the lift equipment is adequate for the load. Work in an empty area. During movement,
always keep the load as close to the ground as possible.
Use the required P.P.E.
The mixer inclines slightly by 10-15 degrees when lifted.
Lifting standards with lift truck: always use a pallet when handling the mixer.
Machine on pallet.
Make sure the lifting device is adequate for the load.
Widen the lifting forks as much as possible and make sure they come out from the pallet.
Work in an area free from persons and animals.
During movement, always keep the load as close to the ground as possible.
Use the required P.P.E.
STORAGE:
Storage of packed mixer:
The mixer must be stored in a closed and covered place, on a smooth and solid surface protected from dust
and filth, sheltered from atmospheric agents and hygienically safe.
The temperatures must remain between –20 and +50°C, and humidity no greater than 90%.
Storage of unpacked mixer.
If the mixer has already been unpacked, in addition to that above, it must be lifted from the ground with a
pallet or other and covered in order to protect it from humidity, dust and filth. If wrapped in cellophane or
another type of plastic, avoid airtight closing below the mixer in order to prevent corrosion linked to
condensate.
ATTENTION! The mixer must not be stored in the open!!
INSTALLATION
The mixer must stand in a vertical position, on a smooth surface sufficiently sturdy for the load (floor
with resistance over 20 km/cm
2
). If in danger of tipping over, anchor the mixer to the floor using 4
plugs or bolts with a traction resistance over kg 300 (M8).
Connection to electrical mains
The electrical connection must be carried out by a specialised electrician, according to the modalities
and standards in force in the country where it is installed. Make sure that the voltage and frequency
of the system are the same as those on the mixer identification plate. Incorrect connection makes
the warranty void.
PRESERVATION OF THE MACHINE
Storage before a long period out of service
Clean the mixer thoroughly.
Disconnect it from the electrical mains.
If possible, put it back into its original packing.
WARRANTY TERMS
Validity: The warranty starts from the delivery date and lasts 12 months, if:
The mixer was not damaged during transportation, and it was installed, commissioned, used and
serviced as prescribed in this manual.
It was not tampered with, modified and no unintended tools were installed on it.
It did not undergo modifications or repairs carried out by the customer or third parties in an
incompliant fashion or without the prior consent of the supplier.