SIGLENT TECHNOLOGIES SDG6000X Series, User Manual, Page: 33 / 198

SDG6000X User Manual 23
Press Waveforms
→ Sine → Amplitude, to set the amplitude parameter. If the
new value is invalid, the instrument will set the value to the closest valid
setp
oint. For example, if you set the amplitude to “0 V”, which is not a valid
amplitude, the instrument will select the nearest valid value. If the high value is
the parameter you wish to set, press Amplitude/HighLevel again to switch to
high level entry.
Figure 2-3 Setting the Amplitude
Note:
If the output load is set to a specific resistance value (not HiZ), the amplitude
unit can be set as “Vpp”, "mVpp", "Vrms", "mVrms" or "dBm".
If load is set as “HighZ”, the amplitude unit can be set as “Vpp”, "mVpp",
"Vrms" or "mVrms".
To Set the Offset
The offset setting range is limited by the “Load” and “Amplitude/HighLevel”
settings. For detailed information, please refer to “SDG6000X Datasheet”. The
default value is 0 Vdc.
Press Waveforms
→ Sine → Offset, to set the offset parameter.
If the new value is invalid, the instrument will set the value to the closest valid
setpoint. For example, if you set the amplitude to “0 V”, which is not a valid