Sierra Flame WM-FML-40, Installation And Operation Instructions Manual

Page: 18 / 27

18
REPLACING THE REMOTE CONTROL BATTERY
When the remote control stops operating or its range seems reduced, it is time to replace the batteries
with new ones. Remove the batteries if
the remote control won’t be used for a long period of time.
1. The battery compartment is located on the back end of the remote.
2. Press the small tab inward as you slide the battery door open and remove the old batteries.
3. Replace with (2) AAA batteries (not included), making sure the + and - sides of the battery match the
inside of the battery compartment.
4. Replace the battery door.
CAUTION:

Always purchase the correct size and grade of battery most suitable for the intended use.

Replace all batteries of a set at the same time.

Clean the battery contacts and also those of the device prior to battery installation.

Ensure the batteries are installed correctly with regard to polarity (+ and -).

Remove batteries from equipment which is not to be used for an extended period of time.

Remove used batteries promptly.
Note:
DISPOSAL OF USED BATTERIES
Note: please operate remote transmitter at a slow measured pace. Press the remote control buttons
with an even motion and gentle pressure. Repeatedly pressing buttons in rapid succession may cause
the transmitter to Malfunction.
Batteries may contain hazardous substances which could be
endangering to the environment and to human health. This symbol
marked on the battery and/or packaging indicates that used battery shall
not be treated as municipal waste. Instead it shall be left at the
appropriate collection point for recycling.
By ensuring used batteries are disposed of correctly, you will help to
prevent potential negative consequences for the environment and human
health. The recycling of material will help to conserve natural resources.
For more information about collection and recycling of used batteries,
please contact your local municipality or your waste disposal service.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbonzinc), or rechargeable (nicad, nimh,etc) batteries.
Caution for Ingestion.