Sierra Flame WM -FM L-26-3223-STL, Installation And Operation Instructions Manual

Page: 17 / 23

17
REM OTE CONTROL OPERATION
For remot e t o funct ion make sure t he heat er is plugged in and main power sw it ch located on t he
bott om left hand side is at posit ion I.
When operat ing t he remot e make sure you point t he remote t o t he cent re of t he fireplace and make
sure each t ime you press t he butt on t he buzzer inside t he unit w ill beep once. It t akes some t ime for
t he receiver t o respond t o t he t ransmitt er. Do not PRESS t he butt ons more t han once w it hin t wo
seconds for correct operat ion.
Power on butt on: The power-on but t on at t op left corner of t he remot e is t he main ON/ OFF
power butt on. This w ill t urn off all t he funct ions and t he fireplace w ill be in st andby mode.
DISPLAY ON/ OFF button : Sw it ching t he fireplace flame and t ray light ON/ OFF. It has funct ions of
set t ing memory.
DISPLAY BLUE button : Adjust t he blue color bright ness of flame and t ray.
DISPLAY YELLOW button
: Adjust t he yellow color bright ness of flame and t ray.
DISPLAY ORANGE button : Adjust t he orange color bright ness of flame and t ray.
M OOD LIGHT ON/ OFF button : Sw it ching t he mood light ON/ OFF.
ADJUST button
: Sw it ching t he color of t he mood light .
FLASH button : Sw it ches t he mood light into flash mode, t his cycles t hrough all mood light colors.
HEATER ON/ OFF button
: Sw it ching t he heater ON/ OFF. It has funct ions of set t ing memory.
HIGHT button : Press t he high butt on t o sw it ch t he heat er t o high heat set t ing 1500W.
LOW button : Press t he low but t on t o sw it ch t he heat er t o low heat sett ing 750W.
TEM P. button : Press t he TEM P. butt on mult iple t imes t o set ambient t emperat ure at
When setting the temperature, the number will flash.
18
℃
(64.4
℉
),
19
℃
(66.2
℉
), 20
℃
(68
℉
), 21
℃
(69.8
℉
), 22
℃
(71.6
℉
), 23
℃
(73.4
℉
), 24
℃
(75.2
℉
), 25
℃
(77
℉
),
26
℃
(78.8
℉
), 27
℃
(80.6
℉
), 28
℃
(82.4
℉
).