Siemens SINUMERIK 802C, Manual

Page: 135 / 142

Manual Machine
7.9 Default assignment of special data for the “Manual machine”
7-135
SINUMERIK 802C
6FC5 597–3AA20–0BP2 (01.02)
MD 12202 $MN_PERMANENT_FEED[2] 2000
MD 12202 $MN_PERMANENT_FEED[3] 3500
MD 14510 $MN_USER_DATA_INT[0] 300
MD 14510 $MN_USER_DATA_INT[1] 20
MD 14510 $MN_USER_DATA_INT[2] 600
MD 14514 $MN_USER_DATA_FLOAT[0] 1000
MD 14514 $MN_USER_DATA_FLOAT[1] 22
MD 14514 $MN_USER_DATA_FLOAT[2] 15
MD 18118 $MN_MM_NUM_GUD_MODULES 2
MD 18120 $MN_MM_NUM_GUD_NAMES_NCK 14
MD 18150 $MN_MM_GUD_VALUES_MEM 30
MD 20150 $MC_GCODE_RESET_VALUES[7] 2
MD 20150 $MC_GCODE_RESET_VALUES[14] 2
MD 20150 $MC_GCODE_RESET_VALUES[27] 1
MD 31090 $MA_JOG_INCR_WEIGHT[AX1] 0.0005
MD 32084 $MA_HANDWH_STOP_COND[AX1] H2ff
MD 32084 $MA_HANDWH_STOP_COND[AX3] H2ff
MD 35040 $MA_SPIND_ACTIVE_AFTER_RESET[AX4] 1
MD 35160 $MA_SPIND_EXTERN_VELO_LIMIT[AX4] 18
Setting data:
MD 41110 $SN_JOG_SET_VELO 500
MD 41120 $SN_JOG_REV_SET_VELO 0.2
MD 41130 $SN_JOG_ROT_AX_SET_VELO 100
MD 41200 $SN_JOG_SPIND_SET_VELO 100
MD 42100 $SC_DRY_RUN_FEED 10
MD 42440 $SC_FRAME_OFFSET_INCR_PROG 0
MD 42442 $SC_TOOL_OFFSET_INCR_PROG 0
MD 43300 $SA_ASSIGN_FEED_PER_REV_SOURCE[AX4] 0
R parameters:
R[4] 1