Siemens Simodrive 1PH7, Planning Manual, Page: 16 / 176

Motor Description
1.3 Technical design, options
1PH7/1-16

Siemens AG, 2004. All rights reserved
Induction Motors, 1PH7 (APH7S) – 05.04 Edition
1.3 Technical design, options
Table 1-2 Options
Technical features Version
Type of construction
1)
All mounting positions are possible
(refer to the Planning Guide “General Part for AC Induction
Motors”)
Cooling
3)
Air flow direction from the non-drive end to drive end
Cable entry
2) 3)
SH 100 to 160
Power cable left, NDE or signal cable left, NDE
SH 180 to 225
Power cable left, DE NDE or signal cable right, NDE DE
Shaft end Cylindrical (acc. to DIN 748, Part 3) with keyway and key
Tolerance zone SH 100 and 132: k6
Tolerance zone SH 160 up to 225: m6
Bearing version
SH 100 to 160, standard
SH 180 to 225
Bearings for a coupling out-drive;
Bearings for a coupling out-drive and increased speed (only
for SH 180);
Bearings for increased cantilever force
Radial eccentricity, concentricity and
axial eccentricity
(acc. to DIN 42955, IEC 60072-1
)
Shaft Heights 100 to 160: Standard
SH 180 to 225: Tolerance, level R
Vibration severity
(acc. to EN 60034-14, IEC 60034-14) SH 100 to 160: Level S
4)
; Level SR (=S/1.6)
SH 180 to 225: Only for coupling out-drive, levels S and SR
Mounted/integrated components The motors can be supplied complete with mounted gearbox
Seal SH 100 to 160:
DE flange with shaft seal (if occasional oil drops or oil mist
lubricate the sealing ring)
1) For shaft heights 180 and 225, it must be ensured that the correct hoisting concept is applied
2) Only in the specified combination
3) Not for core types
4) For core types, included in the basic version