Siemens SIMATIC NET RUGGEDCOM RST2228, Installation Manual

Page: 30 / 58

Installing the Device
2.5.3 Connecting External PoE Power
Note
For IEC 61850 compliance, use an IEC 61850 compliant PoE power supply with pow-
er cabling no longer than 3 m (118 in).
Otherwise, Siemens recommends using the RUGGEDCOM RPS1300 switch-mode AC
power supply. For more information about this power supply, refer to https://sup-
port.industry.siemens.com/cs/ww/en/view/109478699 .
To support the IEEE 802.3at specification (60 W/port output), the external power
supply must meet the following requirements:
Input Range Power Sup-
ply Type
Minimum Maximum
Isolation Minimum Pow-
er Required
DC 51 VDC 57 VDC 1.5 kVAC/2.2 kVDC 150 W
a
a
Based on a single 4-port module.
To support the IEEE 802.3af specification (15 W/port output), the external power
supply must meet the following requirements:
Input Range Power Sup-
ply Type
Minimum Maximum
Isolation Minimum Pow-
er Required
DC 45 VDC 57 VDC 1.5 kVAC/2.2 kVDC 72 W
a
a
Based on a single 4-port module.
To connect an external power supply for the PoE ports, do the following:
1. Secure a European-style terminal block (or Euroblock) to the terminal.
1 2
3 4
3
4
1
Pluggable Terminal Block
2
Screw-Type Terminal Block
3
Positive (+) Terminal for PoE
4
Negative (-) Terminal for PoE
Figure 2.14 Terminal Block Wiring
2. Connect the positive wire from the RUGGEDCOM RPS1300 (or another external
power supply) to the positive (+) terminal on the terminal block.
3. Connect the negative wire from the RUGGEDCOM RPS1300 (or another external
power supply) to the negative (-) terminal on the terminal block.
RUGGEDCOM RST2228P
Installation Manual, 12/2019, C79000-G8976-1403-05
21