Expanding and assigning parameters to the device
6.2 Expansion cards
SIMATIC IPC647E
Operating Instructions, 11/2018, A5E45589180-AA
93
6.
Run the retainer
①
through one of the marked guide notches
②
until the retainer
touches and does not damage the expansion card. While doing this, adjust the expansion
card so that it fits into the slot of the retainer.
Note:
The retainer can only be moved in the direction of the expansion card and snaps into the
selected position.
To remove the retainer you have to push it through until it no longer latches in and then
take it out.
7.
Cut off the protruding part of the retainer as shown. Do not leave any remnants jutting
out.
8.
If you want to change the position later, you must open the top of the bus frame.
9.
Install the bus frame as described in section "Removing/installing the bus frame
(Page 87)" in the device.
See also
